The MILL E-Z™ PUMP-DOWN PLUGS are utilized for multi-stage horizontal completions. All Magnum Composite Plugs can be equipped with Pumpdown wipers for added efficiency in the pumpdown procedure. Once the depth is reached, MILL E-Z™ Pump Down Plugs are then set like a conventional bridge plug. Comprised of proprietary composite material and having a low metallic content, the Mill E-Z™ Pump Down Plug can be quickly and easily milled and circulated back to surface using conventional milling, drilling with a rig and tubing, or with coiled tubing.

 

Mill E-Z™ Ball Drop: After setting, the tool remains open for fluid flow and allows wireline services to continue until the ball drop isolation procedure has started. Once the surface-dropped ball is pumped down and seated in to the inner funnel top of the tool, the operator can pressure up against the plug to achieve isolation.

Mill E-Z™ Bridge: The Bridge Plug, or “Kill Plug”, has a “top venting” ability, which allows for upper and lower equalization during drill out.

Mill E-Z™ Flo-Back: When the pressure below the plug is greater than the pressure above, the one-way check valve will allow the two zones to commingle. The operator can independently treat or test each zone and then remove the flo-back plug(s) in one trip with conventional milling or drilling tools.

Mill E-Z™ Flo-Back with Bio-Ball: Also built with a one-way check valve, this plug temporarily prevents sand from invading the upper zone and eliminates cross-flow problems by utilizing an Aqueous-Soluble Bio-Ball sealer. After the Bio-Ball has dissolved by pressure, temperature, or fluid, the check valve will allow the two zones to commingle. The operator can then independently treat or test each zone and remove the flo-back plug in an under-balanced environment in one trip.